1. 毕业设计（论文）的内容和要求
本课题研究对象为φ36.52.25的厚壁圆筒，采用20号管材，要求采用有限元方法预测厚壁圆筒的爆破过程，所得结果与实验、相关规范及福贝尔公式等经典计算方法比较，并考虑厚度减薄缺陷等的影响，为高压容器的设计提供参考。
要求毕业生主要完成以下内容：①外文资料翻译一篇；②开题报告一份；③文献综述一篇，总文献数不低于30篇，其中外文不少于5篇；④按照学校规范完成毕业论文一篇；⑤CAD图纸不少于3A1。
2. 参考文献
1 | Jones, D.P., Holliday, J.E. and Larson, L.D., 1999, Elastic-Plastic Failure Analysis of Pressure Burst Tests of Thin Toroidal Shells, Trans. ASME J. Press. Vessel Technology, 121, pp.149-153. |
2 | Jones, D.P., and Holliday, J.E., 2000, Elastic-Plastic Analysis of the PVRC Burst Disk Tests with Comparison to the ASME Code Primary Stress Limits, Trans. ASME J. Press. Vessel Technology, 122, pp.146-151. |
3 | Kisioglu, Y., Brevick, J. R. and Kinzel, G. L., 2001, Determination of Burst Pressure and Location of the Dot-39 Refrigerant Cylinders, Trans. ASME J. Press. Vessel Technology, 123, pp.240-247. |
4 | Hill, E.K., Walker,J.L. and Rowell,G.H., 1996, Burst Pressure Prediction In Graphite/Epoxy Pressure Vessels Using Neural Network and Acoustic Emission Amplitude Data, Material Evaluations, 54, pp.744-748. |
5 | Sun, X.K., Du,S.Y. and Wang,G.D., 1999, Burst Problem of Filament Composite Pressure Vessels, International Journal of Pressure Vessels and Piping ,76, pp.55-59. |
6 | Updike,D.P. and Kalnins, A., 1998, Tensile Plastic Instability of Axisymmetric Pressure Vessels, Trans. ASME J. Press. Vessel Technology, 120, pp.6-1 |
7 | 尚晓江等. ANSYS结构有限元高级分析方法与范例应用[M]. 北京：中国水利水电出版社，2006. |
8 | 张朝晖. ANSYS_12.0结构分析工程应用实例解析第3版[M]. 北京：机械工业出版社，2010. |
以上是毕业论文任务书，课题毕业论文、开题报告、外文翻译、程序设计、图纸设计等资料可联系客服协助查找。
